ARRIS C250 V2 Spare Parts
ARRIS C250 V2 250mm fpv racing quads rtf with Skyzone SKY04L V2 fpv goggle boundle comes with everything you needed for FPV. The ARRIS C250 V2 is fully assembled and tested before leaving the factory. Plug the battery, bind the goggle with the video transmitter, you can begin your FPV journey.
--250mm wheelbase with 5" propeller, easy to control
--Stable and durable
--4MM Thicknedd arms, resistant to crash
--Fully assembled and tested, ready to fly
--Powerful X2205 2300kv brushless motor
--F4 flight controller with 30A 4in1 ESC
Dimension:195mm x 230mm x 42mm (Propellers not included)
Diagonal Wheelbase: 250mm
Flight Controller: F4 flight Controller
Frame Material: Pure Carbon fiber
Radio System: Radiolink AT9S with R6DSM receiver
Camera: ARRISHOBBY Cat FPV Camera
FPV TX: 5.8G 200mw 40CH
Antenna: 5.8G Antenna
Flying Time: 10min hovering
Battery: ARRIS 4S 1500mah 50C Lipo
Charger: Skyrc Imax B6AC V2 Charger
Goggle: Skyzone sky04L V2 fpv goggle
ARRIS C250 V2 is made of pure carbon fiber material. With water transfer painting technology,it look so charming. The upper plate and side plate adopts 1.5mm pure carbon fiber material, decrease the weight of the whole frame. Meanwhile, the motor arm adopts 4mm carbon fiber material, ensure the strength of the frame. The total weight of the frame is about 137g.With the simplify one-piece design and lower gravity center design, all kinds of flight actions can be done with facility.The layout design of the C250 V2 is reasonable, the standard flight controller and PDB board can install there.On the frame, there is reserved space for the XT60 female battery connector.The motor arm has holes for 220x series motors, and both 5 inches and 6 inches propellers can install on the C250 V2 frame.
Tower upgrade to Flycolor Raptor S-Tower comes with BLHei-S 4-in-1 40A ESC and F4,PDB and OSD. The ESC comes with EFM8BB21F16G MCU, support Dshot / Multishot / Oneshot,support high KV motor, can support at most 500k eRPM.Dshot is digital signal, anti-interference ability is stronger, and do not need throttle calibration.
The default firmware of the F4 is Betaflight_OMNIBUSF4SD,it supports PPM,SBUS,SPEKTRUM 1024/2048 etc. remote control / receiving mode. Built-in current meter, OSD directly display the real-time current without any additional connection.
With the high performance ARRIS X2205 2300KV brushless motor, the ARRIS C250 V2 has outstanding power.
1. Adopts the brand new M5 steel shaft, improving the structure strength.
2. Anti-slip pro design.
3. Upgrade to centrifugal fan design, optimizing the heat dissipation.
4. Adopts original Japan NSK bearing, improving the performance of the motor.
5. Adopts N52 tile-shaped magnets.
6. The motor passed more than 20 kinds of tests before leaving the factory, ensure the quality of the motor.
The ARRIS C250 V2 adopts with the latest 5045 propeller, it has bigger windward area, well balance and strengthen root, and the efficiency is 10% higher than normal propeller. This propeller is the first choice of FPV racing drones.
ARRISHOBBY CAT 1200TVL Built-in OSD FPV Camera -- This fpv mini camera is specially designed for FPV,It provides some incredible specs for 1200TVL resolution and WDR worldwide.
ARRIS 5.8g 200mW 40-CH video TX and antenna pre-assembled.The ARRIS TS5823L with LED is transmitting a full range of 40 channels and only weighs 10g. It's perfect for a wide range of aircraft!With a goggle or monitor in hand, you can begin your FPV journey.
ARRIS X-Speed C250 V2 has integrated with a remote controller battery warning buzzer, pilot can set the threshold (adjustable) according to CF parameter-adjustment software. In addition, you can also locate your racing drone through triggering the buzzer with the switch D on the transmitter.
Self-level mode is the easiest to fly, because when you leave the stick at the center and not controlling it, your drone just level itself and stays there.This mode is good for beginners.
Manual mode is useful for acrobatics such as flips or rolls, or FPV when smooth and fast control is desired. The picture below is what we set on our own Radiolink AT9S Radio.
RadioLink AT9S Transmitter.The AT9S radio is with high performance-price ratio. And it can support strength, receiver voltage monitored, extending battery voltage, temperature, motor RPM, GPS etc.
High safety ARRIS 4S 1500mah Lipo Battery
ARRIS 4S 1500mAh 50C lipo battery is specially designed for FPV racer. The price of this battery is much higher than the similar batteries in the market, because we only sell top-quality batteries. As we all know, the low quality battery might have potential safety hazard, we will never tolerate such products.
The Skyzone SKY04X V2 is the newest OLED FPV goggle released by Skyzone and it is the first skyzone goggle with focus adjustment. Skyzone SKY04X goggle comes with the 1280*960 high resolution screen, which has vivid color and high contrast ration, pilot can see more details in the racing.
SKY04X FPV goggle comes with the 5.8G 48CH SKY-FUSION receiver, the receiver merge two signal to one, avoid image tearing and rolling, which makes the image more stable and clear in challenging condition.
The new designed optics have focus adjustment feature and 46 degree Field of view, gives pilots more immersive FPV experience.It also supports DVR funactoon that SD card support up to 128GB,and Type C connector to upgarde the firmware or power goggle.
Item: 5.8GHz 48CH SKY-FUSION Receiver 1280X960 FPV Goggles
FOV (Diagonal): 46°
Focus: -6~+6 adjustable
Interpupillary distance(IPD): 58-71mm
Receiver: 5.8Ghz 48CH SKY-FUSIONReceiver
Language: 10 Language
Power Supply: DC6.5-25.2V/USB5V
DVR: H264,60fps,MOV6Mbps,SD Card support up to128Gb
Head Tracker: 3-axis Accelerometer, 3-axisgyroscope
SKYRC IMAX B6AC V2 Professional Balance Charger/Discharger
SKYRC B6AC V2 is a high-performance, micro processor control charge/discharge station with battery management suitable for use with all current battery types, with integral equalizer for six-cell Lithium- Polymer (LiPo), Lithium iron phosphate(LiFe) and Lithium-Ion (LiIon) batteries; maximum 6A charge current and maximum 50W charge power.
AC Input Voltage: 100-240V
DC Input Voltage: 11-18V
Circuit Power: Max Charge: 50W /Max Dischage: 5W
Charge Current Range: 0.1-6.0A
Discharge Current Range: 0.1-2.0A
LiPo/LiFe/LiIon Cells： 1-6S
Pb(Lead Acid) battery Voltage:2-20V
Net Weight: 632g
Dimension: 135 x 144 x 36mm
1 x ARRIS C250 V2 Racing Quad Frame
4 x ARRIS X2205 2300KV Brushless Motors
1 x Flycolor S-Tower w/30A 4 in 1 ESC + F4 + OSD + PDB
4 x ARRIS 5045 3-blade Propeller
1 x ARRISHOBBY CAT 1200TVL FPV Camera
1 x 5.8G 200mw 32CH FPV TX
1 x FPV Transmitter Antenna
1 x Radiolink AT9S Transmitter with receiver
1 x ARRIS Buzzer
1 x ARRIS 4S 1500mah Lipo Battery
1 x SKYRC IMAX B6AC V2 Balance Charger
1 x Skzone SKY04X V2 FPV Goggles
Note: You may receive two parcels for this whole order. One is the drone with charger, and the other is the goggle.