Holybro  |  SKU: 15020

Holybro PM06D 2-14S High Voltage Power Module

$33.99


Customer Reviews

Be the first to write a review
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)

Holybro PM06D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. It has built-in power distribution, allowing you power your ESC and FC with the same board.

It is suitable for Holybro Pixhawk 5X & 6X Flight controller and other FMUv6X flight controllers.

The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with a XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Specification
Item Brand: Holybro
Item Model: PM06D
Input voltage: 2S- 14S
PCB Cont. Current Rating: 70A
PCB Burst Current Rating: 120A (<60 Sec)
Max current sensing: 327A
Voltage and current monitor with I2C compatible interface 
Connector Outputs: 5.2V and 3A max 
Weight: 24.5g

Current Rating:
The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as reference.

PX4 Parameter Setup:
If you are using the PM06D 14S version, you must set SENS_EN_INA228 to enable.

Package Includes:
1x  Holybro PM06D Power Module
1x  6pin 2.00mm pitch cable

Holybro

Holybro PM06D 2-14S High Voltage Power Module

$33.99

Holybro PM06D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. It has built-in power distribution, allowing you power your ESC and FC with the same board.

It is suitable for Holybro Pixhawk 5X & 6X Flight controller and other FMUv6X flight controllers.

The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with a XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Specification
Item Brand: Holybro
Item Model: PM06D
Input voltage: 2S- 14S
PCB Cont. Current Rating: 70A
PCB Burst Current Rating: 120A (<60 Sec)
Max current sensing: 327A
Voltage and current monitor with I2C compatible interface 
Connector Outputs: 5.2V and 3A max 
Weight: 24.5g

Current Rating:
The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as reference.

PX4 Parameter Setup:
If you are using the PM06D 14S version, you must set SENS_EN_INA228 to enable.

Package Includes:
1x  Holybro PM06D Power Module
1x  6pin 2.00mm pitch cable

View product