ARRIS High-Speed Aerosol Spray Nozzle 2L Flow Atomizing Nozzle for AG Spraying Drones

ARRIS High-Speed Aerosol Spray Nozzle Pro 2L Flow Dual-Cavity Disc Atomizing Nozzle




Parameter:
Item model: 4808
Voltage Range: 12s-18s
Current Range: Within 4A
Speed Range: 16000 RPM
Maximum Flow Rate: 2L
Atomization Microns: 50-100 microns
Spray Width: 6-8 meters
Rated Power: 50-150W (defined by flow rate and speed)
Control Method: PWM
Weight: 290g
Operating Temperature: -10 to 50°C
Protection Rating: IP55
Control Mode: Stepless speed regulation
Speed Feedback: None
Inlet/Outlet Pipe Diameter: 6-8mm
Plug Specification: Quick plug
Cable Length: 1.25 meters

Cable Definition: 
Red -- Positive
Black -- Negative
White -- Signal 
Yellow -- Ground

Product Usage Instructions:
1. Do not run the nozzle dry. Ensure the water pump is running simultaneously (the flow of liquid is necessary to cool the nozzle motor).
2. When using a 12S power supply, set the nozzle speed to 95% (analog range 1000-1950).
3. When using a 14S power supply, set the nozzle speed to 85% (analog range 1000-1850).
4. When using an 18S power supply, set the nozzle speed to 75% (analog range 1000-1750).
5. Turn off the nozzle when the liquid is depleted (some flight controllers do not have a centrifugal nozzle mode and require manual shutoff).
6. After each operation, fill the tank with clean water and cleaning solution. Run the centrifugal nozzle and spray the entire tank of water, then let it idle for 30 seconds. This is to thoroughly clean out any residual pesticide, preventing corrosion, solidification, and damage to the motor bearings.