Holybro PM02D High Voltage 2-12S Power Module

Holybro PM02D provides regulated power supply for your Pixhawk® 5X & 6X from the battery,  as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 12S (HV). The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection.

It is suitable for Pixhawk 5X & 6X and other FMUv6X FC. It is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers.

Specification:
Item Brand: Holybro
Item Model: PM02D
Input voltage: 2S-12S
PCB Cont. Current Rating: 60A
PCB Burst Current Rating: 100A (<60 Sec)
Max current sensing: 327A
Voltage and current monitor with I2C compatible interface 
Outputs 5.2V and 3A max 
Weight: 20g

It is not designed to power servos, please use your aircraft's ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Current Rating:
The PM02D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly.

PIN MAP:

Setup:
If you are using the PM02D HV version, you must set SENS_EN_INA228 to enable.

Package Includes：
1x  Holybro PM02D Power Module
1x  6pin 2.00mm pitch cable